HG2000P 10
OPERATION /MAINTENANCE AND CLEANING
3.5 Stripping paint
- Mount an appropriate accessory.
- Set a high air temperature.
- Switch the tool on.
- Direct the hot air onto the paint to be removed.
- When the paint softens, scrape the paint away
using a hand scraper.
Do not strip metal window frames, as
the heat may be conducted onto the
glass and crack it. When stripping other
window frames, use the glass protection
nozzle.
Do not keep the tool directed at one
spot too long to prevent igniting the
surface.
Avoid collecting paint on the scraper
accessory, as it may ignite. If necessary,
carefully remove paint debris from the
scraper accessory using a knife.
3.6 Stationary use
This tool can also be used in stationary mode.
- Place the tool onto the workbench.
- Secure the cable to prevent pulling the tool off
the workbench.
- Carefully switch the tool on.
WARNING:
- Make sure that the nozzle always points away
from you and any bystanders.
- Make sure not to drop anything into the
nozzle.
3.7 Cooling down
The nozzle and accessory become very hot
during use. Let them cool down before
attempting to move or store the tool.
- To reduce the cooling time, switch the tool to
position I which is at the lowest air temperature
and adjust the air flow to Max. and let it run for
a few minutes.
- Switch the tool off and let it cool down for at
least 30 minutes before storage.
MAINTENANCE AND CLEANING
Attention! Before performing any work on the
equipment, pull the power plug.
Maintenance
Your Power Tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Cleaning
- Keep the ventilation slots of the machine clean to
prevent overheating of the engine.
- Regularly clean the machine housing with a soft
cloth, preferably after each use.
- Keep the ventilation slots free from dust and dirt.
- If the dirt does not come off use a soft cloth
moistened with soapy water.
Never use solvents such as petrol, alcohol,
ammonia water, etc. These solvents may damage
the plastic parts.
