HG2000P 09
OPERATION
WARNING:
- Make sure that the tool is switched off and
the nozzle has cooled down.
- Falling down nozzle can set an object on fire.
Nozzles must be mounted firmly and secure on
the unit.
- Touching a hot nozzle can lead to serious
burns .Before attaching or replacing a nozzle,
allow the unit to cool down completely or use a
suitable tool.
- A hot nozzle can set a surface on fire. Place
down hot nozzles only on fire-proof surfaces.
An incorrect or defective nozzle can lead to
heat accumulation and damage the unit. Use
only original nozzles according to the table that
are suitable for your unit.
3.Instructions For Use
- Always observe the safety instructions and
applicable regulations.
- Use only one hand to hold the tool, do not
place your other hand over the air vents
Prior to operation :
- Mount the correct accessory for the
application.
- Set the desired air temperature.
3.1 Switching ON and OFF
- To switch the tool on, set the on/off switch to
position I / II. Some smoke may be emitted after
switching on; this does not indicate a problem.
- To switch the tool off, adjust the lowest
temperature to cool off, then set the on/off switch to
position 0. Let the tool cool down before moving or
storing it.
3.2 Temperature and airflow settings.
a. Turn ON/OFF Switch to I or II, and the heat
gun will start to buzz.
b. Turn ON/OFF Switch to II.
- Increase or decrease the output temperature
by clicking the Buttons 7,8.
Temperature adjusts at scale of 10
℃
.
The Flasher 4.2 will keep flashing before output
temperature reaches the setting temperature.
- Adjust air flow by clicking the Buttons 9,10.
c. Turn ON/OFF Switch to I, the temperature is
fixed at 50
℃
for cooling down.
3.3 Preset mode selection
- 4 preset modes are available for quick slection of
temperature and airflow setting for most frequent
and defined applications.
- Turn on the tool. Click the button the Mode
Selection Button 6 to select one desired mode of
preset temperature and air flow.
3.4 Preset mode input
- Select one preset mode according
- Set desired temperature and airflow by clicking
buttons 7,8,9,10. During the process, the symbol
of Preset Input (4.1) keeps flashing.
- Then keep the Storage Button 5 pressed for 2
seconds until the the symbol of Preset Input (4.1)
disappear. The new temperature and airflow
setting is stored into the preset mode for quick
selction.
