Lumberjack EP82-3, Safety And Operating Manual

Page: 11 / 18

Unt
EP82-3 09
Adjusting a Cutter
With the planing depth set to zero, place a
straight edge along the bottom face of the
machine. The cutter blade should just touch
the straight edge.
If adjustment is necessary, screw the hex
socket head screws in or out as required, until
the cutter blade just touches the straight
edge, along its entire length I.E the blade
must be parallel across the base of the
machine.
Replacing the Drive Belt
Should the cutter bind in the workpiece, it is
probable that the drive belt needs changing.
Should this be the case, please proceed as
follows:
- Remove the three securing screws,
and pull off the cover.
- Pull off the old belt by turning the
larger pulley whilst pushing the
belt towards you in the middle of
its run, so that it gradually eases of
the pulleys – take care not to trap
your fingers between the belt and
pulley.
- Replace the new belt in a similar
manner, turning the large pulley
whilst pushing the belt over the
ridges in the pulleys.