Lumberjack EBS100VS, Safety And Operating Manual

Page: 8 / 16

06
OPERATING
INSTRUCTIONS
TOOL SET UP
WARNING!
To prevent SERIOUS Injury from accidental
operation:
Make sure that the Trigger is in the off posion
and unplug the tool from its electrical outlet
before performing any procedure in
this sec
ti
on.
1) Secure the Dust Bag to the tool.
2) Before use, make sure that the
Sanding Belt is on-center. To check this,
plug in the sander and hold the Belt
clear while carefully turning on the
tool.
If the Belt moves to one side or the
other during use, turn the tracking
Knob un l it stays on-center.
WORKPIECE AND WORK AREA SET UP
1) Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distrac on and injury.
2) Route the power cord along a safe route to
reach the work area without crea ti ng a
tripping hazard or exposing the power cord to
possible damage. The power cord must reach the
work area with enough extra length to allow free
movement while working.
3) Secure loose workpieces using a vise or clamps
(not included) to prevent movement while
working.
4) There must not be objects, such as u ti lity lines,
nearby that will present a hazard while working.
GENERAL OPERATING INSTRUCTIONS
1) Make sure that the Trigger is not engaged,
then plug in the tool.
2) To start the tool, squeeze the Trigger; release
the Trigger to stop. For con ti nuous opera ti on
squeeze the Trigger and push the Trigger Lock to
lock the tool on
3) To turn the tool off with Trigger Lock
engaged, squeeze the Trigger once and then
release.
4) Adjust the sander speed to suit different
working material. Turn the Speed Control Knob to
a higher number for a f aster speed or to a
lower number for a slower speed. Determine
the op ti mum speed by tes
ti
ng on a scrap piece
of material.
5) When sanding, use both hands to hold the
tool and sand along the grain for best results.
6) Hold the tool lightly on the workpiece and
allow the tool to do the work. Do not push down
on the Belt Sander or move it along the surface
too fast.
7) To prevent accidents, turn off the tool and
unplug it a fter use. Clean, then store the tool
indoors out of children’s reach.
EBS100VS