Lumberjack BTS210, Safety And Operating Manual, Page: 12 / 23

BTS210 10
OPERATION & WORKING ADVICE
– Adjust the angle of the blade by turning
adjusting handle (
12
), until you achieve the
desired angle, displayed on scale ( 13 ), and
then tighten the locking handle ( 14 ) to lock the
blade into position.
Working Advice
General Sawing Instructions
– For all cuts, it must first be
ensured that the saw blade at no
time can come in contact with the
stops or other machine parts.
– Use the machine for grooving or
rebating only with an appropriately
suitable protective device (e. g. a
tunnel blade guard).
– Do not use the machine for
cutting slots (stopped grooves).
Protect the saw blade against impact and
shock.
Do not subject the saw blade to lateral
pressure.
The riving knife must be in alignment with
the saw blade to avoid jamming of the
work piece.
Do not saw warped/bent work pieces. The
work piece must always have a straight
edge to face against the parallel guide.
Always keep/store the push stick with the
power tool.
Position of the Operator
– Do not stand in a line with the saw
blade in front of the machine. Always
stand aside of the saw blade.
This protects your body against possible
kickback.
– Keep hands, fingers and arms away from
the rotating saw blade. Observe the
following instructions:
– Hold the work piece securely with both
hands and press it firmly against the saw
table.
– When sawing narrow work pieces and
bevel angles, always use the supplied
hold‐
down stick
.