LUMASCAPE ASIA PACIFIC
Brisbane Technology Park, 18 Brandl Street, Eight Mile Plains, QLD 4113, Australia
Phone +61 7 3854 5000 | Fax +61 7 3854 5001 | Email: [email protected] |
www.lumacape.com
LUMASCAPE NORTH AMERICA
1300 Industrial Road, Unit #19, San Carlos, CA 94070, USA
Phone +1 650 595 5862 | Fax +1 650 595 5820 | Email: [email protected] |
www.lumacape.com
Products and specifications are subject to change without notice.
6 / 7
IN0167 181126 CE UL
INSTALLATION INSTRUCTIONS
INGROUND / INGRADE
LED UPLIGHT
USA I Australia I Asia I Middle East I Europe
Erden
E8
LS3080
Installation
Step 2
Step 1
Layout luminaire locations as required.
Use discretion in placement as
luminaire may become hot and could
burn. Luminaire cavity should be
as shown. Ensure gravel or similar
medium forms the bottom of the cavity
to allow drainage.
Note:
Always check luminaire lable for
correct supply details and lamp type if
applicable.
Position and use screws to attach
brackets at the bottom of the mounting
collar before concrete is poured.
Fit sleeve, collar and cover plate.
•
Fit sleeve and collar over foam
plug.
•
Ensure enough cable is in the
cavity to connect to luminaire.
•
Position top surface of the
mounting collar to be flush with
final surface level.
•
Screw cover plate to mounting
collar.
•
Ensure ample depth for fitting.
Step 5
Step 6
Step 4
Pour concrete. Check that the top
surface of the mounting collar is flush
with the finished surface level.
When ready to install luminaire;
•
Destroy foam plug and assemble
luminaire.
•
Remove cover plate, glass and
seal.
Connect cable / hookup wire in
accordance with local wiring rules.
IMPORTANT:
Power supply must
be isolated prior to connection or
disconnection of cables. Failure to do
so will result in damage to the luminaire
components.
IP68
Step 3
gravel
hole
10.3”
Ø262mm
finished surface
19
.4”
(494mm)
Finished
Surface
Level
Factory
supplied
anti-leach
cable
Minimum length of
cable protruding
from the ground to
be 100mm.
