Lumagen Radiance 2123, Owner'S Manual

Page: 25 / 46

Section 5 – Video Configuration
Copyright 2009-2014 Lumagen, Inc. Radiance 2124 and 2144, Rev 051514 17
Screen Aspect Ratio
Selects the screen aspect ratio. The screen aspect ratio range is 1.10 to 2.50 and is entered in units of hundredths
(e.g. 16:9 is entered as 1 7 8). If you have a normal fixed aspect display, select the “Single output aspect” which
is the default setting. If you have a movable anamorphic lens, select “Output aspect per input aspect.”
For the “Output aspect per input aspect” mode, there is a special case when you use NLS. When the input aspect
is 4.3+NLS the output aspect assigned to the 16:9 entry is used. When the input aspect is LBOX+NLS, 16:9+NLS,
or 1.85+NLS the output aspect assigned to the 2.35 entry is used. The command is:
MENU 0 6 (Single output aspect, Output aspect per input aspect) OK xxx OK
Or
MENU → Output → Styles → [Style] → Aspect Ratio → (Single output aspect, Output aspect
per input aspect)
→
Ok
→
xxx
→
Ok
Graybar Intensity
NOTE:
Consult a home theater specialist for assistance setting the graybar intensity.
Some degree of burn-in will occur on any susceptible displays, but this command can help minimize it by allowing
the intensity of the graybars to be adjusted. Set to “0” for black. The command is:
MENU → Output → Styles → [Style] → Graybar → (Sides, Top/bottom)
3D Glasses Adjust
When using the Radiance to control 3D glasses timing, such as with a CRT projector, this setting adjusts the timing
offset of the 3D glasses. This delay is combined with the global delay setting under the MENU → Other → I/O
Setup
→
3D Glasses menu. This command has no effect if the 3D display is controlling the 3D glasses. The
command is:
MENU
→
Output
→
Styles
→
[Styles]
→
3D Adjust
Soft Edge
Rounds off the outside edges of the video, which gives movies a bit more of a theater look and can hide some
issues at edges of displays. The command is:
MENU → Output → Styles → [Styles] → Soft Edge
Misc. Output Settings
3D Output EDID Configuration
By default the display’s 3D capability is automatically detected using its EDID information. However, some 3D
displays do not properly report their 3D capability in their EDID. This command allows the 3D output capability to
be manually set. The command is
MENU
→
Output
→
3D Options
→
Out1/Out2 is 3D Capable
→
(Off, Auto, On).
For a dual projector 3D setup using two Radiances, each Radiance can be set to output only the right or left eye.
The command is
MENU → Output → 3D Options → If 3D show → (Both Eyes, Left Eye Only, Right Eye Only).
Sync Polarity
By default the output sync polarity is selected automatically. This command allows the user to override the
automatic selection for each output. The command is
MENU → Output → SyncPolarity.
Copy Output Settings
This command copies the current output Mode/CMS/Style settings to the selected output Mode/CMS/Style. The
command is:
MENU
→
Output
→
Copy
→
OK