Ludlum Measurements 4525 GENERATION IV Series, Installation Manual

Page: 6 / 77

LMI/RSD Form Rev 1.1 jmg 6 Aug 2019
DESIGNER AND
MANUFACTURER
OF
Scientific and Industrial
Instruments
LUDLUM MEASUREMENTS, INC
.
501 Oak Street
P.O. Box 810
Sweetwater, Texas 79556
Website: www.ludlums.com
(800) 622-0828 / (325) 235-5494
Ludlum Model 4525 Site Photo Requirements
This list of Photos and the Check List must be submitted to rsdtech@ludlums.com prior to scheduling the Commissioning and Start-up
of your system. If no email is available these may be Faxed to (325) 235-8768.
Please be aware there will be additional charges in the case of delays incurred if site is not prepared by arrival.
Yes/No/NA Pre-Commissioning & Start-up Site
3 different angles minimum— Photo(s) showing both detectors in relation to the scale and to ensure the 10
Foot (3M) buffer zone is adequate. (REF: Installation Manual 4511-375) .
1 each— showing the Control Box mounted on the back side of detector #1 stand and height from ground for
easy accessibility, as specified in Installation Manual.
2 each— Face of each detector, with doors closed, showing the placement of all infrared sensors.
2 each— Face of each detector, with doors Opened, showing cables pulled through conduits and 24 inches
(61cm) over pull.
2 each— interior of the control box showing the A/C power lines, both detector cables, auxiliary remote cable,
sensor wiring and the Cat-5e network cable with 24 inches (61cm) over pull.
1 each— (If applicable) Photos of the horn/strobe unit and/or camera and/or traffic light, and/or Wireless P2P
system (both antenna mounted with unobstructed signal path and connecting cables on each end), mounted
with conduit(s) and entering the control box.
2-4 each— Photo(s) showing the mounted computer, printer and network equipment and cables with Cat5e
cable connecting exterior detector, if using purchased system from Ludlum. Photo(s) should reflect the
placement of the computer, monitor and printer after installation whether customer supplied or purchased
with the system(s). The system will be easily accessible and the monitor should be at eye level seated or
standing.
1 each— Photo of the interior auxiliary remote mounted in its location (if purchased). The photo should also
include the cable from the external detector in proximity to the remote.
1 each— Photos of any additional equipment and its location with respect to its function; such as wireless
access points and antennas. These photos should clearly depict the wiring has been installed to control
these devices.
Additional photos— any obstacles, barriers, or other anomalies that could possibly impact the installation and opera-
tion of the system as designed should be documented and presented photographically with the required photos and
noted below in the comments field.
Comments:
Company: ______________________________________________________
Location: ______________________________________________________
Signature/Date: __________________________________________________