11
1
2
Connecting machine to power source
Before connecting the power supply, make sure that the voltage
shown on the rating plate is conforming with your main power.
Put the machine on a stable table.
1. Connect the machine to a power source as illustrated
2. Turn the power switch to on (“I”)
The sewing lamp will light up when the switch is turned on.
Foot control
When the machine is off, insert the foot control plug into its
connector on the machine.
Turn on the machine, and then slowly press down the foot control
to start sewing. Release the foot control to stop the machine.
User can quickly kick one step on the foot control to change the
needle position and set the stop position at the same time.
Attention:
Always make sure that the machine is unplugged from power
source and the main switch is off (“O”), when the machine is not
in use and before inserting or removing parts.
Note:
Consult a qualified electrician if in doubt on how to connect the
machine to the power source.
MACHINE INTRODUCTION
