11
2-2-2
JP10 - CMOS Status
JP10 is a 3-pin connector. Clear CMOS if system password is forgotten. Below is
details to show how to clear CMOS.
Procedure to clear CMOS:
Step 1: Shut down the system and disconnect the power supply from AC power.
Step 2: Pull out the ATX cable from ATX connector “PW1”
Step 3: Short the CMOS jumper by putting jumper cap on Pin 2-3 for a few seconds.
Step 4: Return to pin 1-2 for normal setup.
Step 5: Link ATX power cable to ATX connector & connect AC power to power supply.
Step 6: Turn on system power.
If you’d like to set password, press “Del” Key during system bootup to enter CMOS setup
and establish a new password.
1
2
3
1
2
3
1-2:norm al
2-3:clear C M O S
C M O S Statu s
