VIA693/693A 11
Step 1: Shut down the system and disconnect the power supply from AC power.
Step 2: Pull out the ATX cable from ATX connector “ATX1”.
Step 3: Short the CMOS jumper by putting jumper cap on Pin 2-3 for a few seconds.
Step 4: Return to pin 1-2 for normal setup.
Step 5: Link ATX power cable to ATX connector & connect AC power to power supply.
Step 6: Turn on system power.
If you’d like to set password, press “Del” Key during system bootup to enter CMOS
setup and establish a new password.
2-2-2
SW1 Pin1 – Pin2 : CPU Frequency Selector
SW1 is a 6-pin DIP switch and Pin1 - Pin2 is the CPU Frequency selector. Select the
right frequency according to your CPU, and see details as below.
SW1
CPU BUS FREQUENCY
SW1 : Pin1-Pin2
CPU Frequency Selector
1
ON
DIP
2 3 4 5 6
