3.2.5 The side of the head:
3.2.5.1. Attach comb guide size: 3mm - 6mm to trim
the sideburns.
3.2.5.2. Attach the longest comb guide size
9mm/12mm again and continue until you reach the top
of the head.
3.2.6 The top of the head:
3.2.6.1.
Attach comb guide size 9mm or 12mm, pass
the appliance from the back to the front, against the
growth of the hair (Fig 5). In some cases it’s necessary
to go over what you have done a second time from
front to back.
3.2.6.2. Attach comb guide size 3mm or 6mm when
you want to achieve a more precise cut.
- Use comb guides size 12-15mm to leave hair at a
longer length. Hold the hair up with the comb or the
comb and your fingers and cut.
3.2.6.3. Always work from the back to the front reduc-
ing the length between your fingers or the comb and
the head gradually.
3.2.7 The final touch:
3.2.7.1. Finally use the appliance without attaching any
comb guides to the blades to cut the hair around
the base of the neck, the sides of the neck and
the ears.
3.2.7.2. To make the sideburns straight, turn the ap-
pliance
over to use the upper blades (Fig 6). Move the
appliance adapting it the physiognomy of the
head.
3.3 Once you have finished using the appliance:
3.3.1. Allow appliance to cool down.
3.3.2. Unplug the appliance from the mains power
supply.
3.3.3. Clean the appliance as described in the cleaning
section.
3.3.4. Put the protective cover back on.
4. Cleaning
4.1. Disconnect the appliance from the mains power
supply and allow it to cool completely before undertak-
ing any cleaning task.
4.2. Clean the removable crumb tray with a
damp cloth and dry.
4.3. Clean the outer parts of the appliance with a damp
cloth with a few drops of washing-up liquid and then
dry. CAUTION! Do not immerse electrical parts of the
appliance in any liquid.
4.4. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.5. Never submerge the appliance in water or any
other liquid or place it under running water.
4.6. During the cleaning process, take special care with
the blades, as they are very sharp.
4.7. Clean the blades and the comb guides with the
cleaning brush. Remove the hairs from the blades and
from inside the appliance with the brush. It is important
to clean off remaining hairs after each use.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
Summary of Contents for Master Barber Kit HCL07AC
Page 8: ......
