Lucent Technologies PortMaster OR-HS, Hardware Installation Manual

Page: 43 / 70

Troubleshooting A-7
Observing Boot Messages
Testing High Memory ERROR at failed
memory address This error indicates a startup failure. Record all
information to this point and contact Lucent
Remote Access Technical Support.
PCMCIA slot
(OR-M only) PCMCIA card type PCMCIA card type.
ISDN Found in Slot 0 -
Testing memory
(OR-ST, OR-U only) 512K ISDN interface found. Test of ISDN memory in
progress.
Found x Ports 1, 2, 3 Number of ports detected. Note that S0 is one
port and PCMCIA is another. The ISDN BRI
counts as two ports.
Ether0 active 16K burst - IO Ethernet interface found; 16Kbps is detected as
the maximum amount of data that can be input
or output at any given time on the Ethernet
interface.
Running ComOS N/A If the system becomes suspended at this point
and does not print the next message, the
configuration of nonvolatile RAM has been
corrupted. Refer to the troubleshooting chapter
of the PortMaster Configuration Guide for
instructions on nonvolatile RAM recovery.
PortMaster Console
login: N/A System is up and running.
Table A-2 Interpreting the Diagnostic Boot Messages (Continued)
Field Possible Message Explanation