3
Connect the free end of
each line cord to the
appropriate network interface jack.
4
A)
B)
5
A)
B)
C)
D)
6
A)
B)
C)
D)
Test the lines—plug a system phone into
extension jack 10. Press the line buttons for
each outside line and listen for dial tone.
Repeat for extensions 16, 22, 28, 34, 40, 46
and 52 (if available).
Connect modular telephone cords to 206
module extension jacks, starting at the top
extension jack on the leftmost module.
Route each cord through the hook on the front
of the module.
Connect the free end of each modular
telephone cord to the modular connecting
blocks for system extensions.
Dress the wires. Gather the line and extension
cords hanging below the hooks of the first two
modules and twist tie or wire wrap them.
Repeat for the remaining cords. Place each
bundle of wires in the indentations cut out of
the bottom edge of the backplanes.
Before installing the cover, make sure all modules
are seated properly in the carrier. The cover
will not fit if the modules are not seated
properly.
To cover the modules, grasp the upper edges of
the cover and hold it squarely over the control
unit. It is important to install the cover to keep
the modules dust-free and the system working
efficiently.
Place the cover over the modules and make sure
it fits firmly in place.
Insert the screw into the tab on the lower front of
the cover. Tighten the screw.
Screw
Installation Procedures
11
