Installation Instructions
2 |
P a g e
Installation preperation
Before carrying out the installation the following must be considered.
•
1 x 9VDC (size) battery is required to operate the remote controller. Remove the battery cover from the back of
the remote and plug battery into the battery connector (Battery not included).
•
The remote (transmitter) and receiver must be configured so that communication between each other is paired
up. This is achieved by setting the DIP Switch on the receiver and remote on the same setting.
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code combinations. This
is practical when there is more than 1 remote/receiver pair operating locally or in the same room.
Fig.1 Battery compartment Fig. 2 Dip switch
Installing the receiver
FOLLOW THESE INSTRUCTIONS
-
IF YOUR CEILING FAN MOTOR HANGS DOWN FROM THE CEILING ON A ROD. FOLLOW ALL SAFETY
INSTRUCTIONS IN YOUR CEILING FAN INSTRUCTION MANUAL.
-
REMEMBER TO REMOVE ELECTRICAL POWER BEFORE STARTING WORK.
-
WIRING MUST MEET ALL ELECTRICAL WIRING CODES.
MAKING THE ELECTRICAL CONNECTIONS (see Fig. 2)
Use the wire nut terminal block provided for making connections.
WARNING – HIGH VOLTAGE
BEFORE CONNECTING THE RECEIVER & CHANGE CODES
-
For your safety: Power to the circuit must be disconnected or switched off.
-
Household power can cause SERIOUS INJURY or DEATH
-
Wiring must meet all local and national electrical wiring codes
