19
3-3-2 DIN connector connection procedure
Step 1: Remove the DIN connector from the pump body.
Step 2: Remove the screw from the DIN connector, and then remove the terminal
with a flat-head screwdriver.
Step 3:
Step 4: Connect wires.
Strip the cable end and wires (25 mm of cable sheath and 5 mm of wire sheath),
and then insert the cable end through (1) a tightening gland, (2) a gland washer,
(3) a gland gasket, and (4) a connector cover.
Remove the screw.
Insert a flat-head screwdriver in the point marked
by
"▲,"
and then pull the terminal out.
(4)
(3)
(2)
(1)
Untighten the terminal screw with a flat-head
screwdriver.
Tighten the stranded wire.
Wire
Stranded wire
