5.3.8 Output Limiter
a. Output level limiter
Allows to keep the signal of each individual output within a set level.
It
can be used effectively to protect the components of a sound system.
The following editable parameters are available:
b. Reaction times
Allows to choose between 3 types of Limiter reaction speed.
In fact, these are attack and release times that are optimised so that the Limiter reacts more or less rapidly
when the signal exceeds or drops below the threshold:
Fast
Normal
to mid frequencies or full-range systems.
Slow
suited to outputs dedicated to low frequencies.
Normal: leaves the phase unchanged
Reverse: shifts the phase through 180 , inverting it.
LIMITER
FAST
NORMAL
SLOW
ATTACK
RELEASE
1 ms
10 ms
8 ms
80 ms
45 ms
450 ms
O P 1
N o r m
P O L A
a I
R I T Y
O P 1
e v e r
P O L A
s e
R I T Y
R
O u t p u t
L i m i t e r
O P 1
f
L I M I T E R
f
o
s
a
F
t
short times, suited to rapid Limiter operation. Normally more suited to outputs dedicated to high
frequencies.
intermediate times, suited to the majority of applications. Normally more suited to outputs dedicated
long times, suited to avoiding rapid repeated level jumps (pump effect). Normally most
The effect of this control is summed with that of the
parameter of the
filter (
menu),
which operates with 5 steps in a range of between 0 and 180 .
LPF
Xover - EDIT
In this way it's possible to set the phase of each individual output with 5 steps within a complete 360 revolution,
a very useful function when assembling arrays of speaker enclosures, in the control of the interpolation between
various enclosures or between sections of the same system.
Note:
The level of each output is shown by the respective OUTPUT LEVEL LED ladder. To avoid distortion, don't
let the red CLIP LED light up. As automatic protection, you can also enable the LIMITER (EDIT menu) on the
outputs that require it. In this case, remember that enabling the LIMITER changes the display mode on the
relative LED ladder: in fact, the level shown is no longer the absolute output level, but the level of the signal In
relation to the LIMITER threshold.
5.3.7 Output Pol
Controls the output's polarity.
Allows to invert the phase of the signal of individual outputs.
Editing values are:
O u t p u t
P o l
5. THE MENU MAP CONFIGURATION DESCRIPTION
19
