- 28 -
5.6
FAQs on MMS Function
I set up a new receiving phone number. But the MMS pictures are still being sent
to the old number. What should I do?
Switch the camera OFF. Wait for at least two minutes. Then switch it ON.
Or, switch the camera OFF, take all battery out of the camera, and then reinstall it.
Why did it take so long to receive the MMS pictures / why didn’t I receive any
MMS pictures?
The most common reason is that the signal was too weak. Try different spots. Or
the batteries ran out.
I programmed the camera to constantly take pictures. But some pictures were not
sent to my phone. How?
The Ltl-6310M series camera is designed to constantly send MMS pictures to the
recipient’s phone. However, if the signal is too weak, it may not work stably.
Why did I receive some pictures with partial image, and some with red “X”?
The camera was in motion when sending pictures. Or the signal was unstable.
I was pretty sure the battery was quite low. But I didn’t get any text alert. Why?
The camera “assumes” you install new batteries when you start the camera. It
tracks the usage of the batteries and texts you when the power is low. However, if
you replace the present batteries with some “used” ones at a point before receiving
a text alert, the camera will get “confused” and not send a text alert later on.
My cell phone shows strong signal. Why does the display on the camera not show
the MPNO’s name or signal?
Take all of the batteries out from the camera, and then reinstall it. Switch to TEST
mode. Wait for about 45 – 60 seconds, and the check the signal on the LCD
display.
I just installed the upgrading firmware. Do I need to set up the camera and the
MMS function?
Yes. After you upgrade the camera, all previous settings of the camera and the
LTL ACORN®