- 17 -
slightly move the camera to make sure the LED light in the front keeps flashing. If you wait
too long (over three minute), the screen may power off to save battery. If that happens, you’ll
need to switch to OFF and then TEST to start over.
Signal strength can be full 6 columns. To make the MMS module to work, at least two bars are
required. If you only see one bar, the reception is too weak for the MMS to function.
Some U.S. AT&T customers will see a six-digit number (310410), instead of the operator’s
symbol, next to the signal bars. It is normal. If a code other than the MPNO symbol shows up on
the screen, it indicates something is wrong. Specifically,
SIM
: No SIM card or installed incorrectly.
CSQ
: No signals.
CREG
: SIM card is password-protected, or deactivated due to low balance in the
account, or not able to register with the GSM system.
CGREG
: Not able to register with GPRS network.
COPS
: Searching for the MPNO of the SIM card. Once found, the operator’s symbol
and the signal strength will show on the display.
If
No MM1
shows on the screen, it means the MMS-module is not found or not installed. If your
camera is a standard Model Ltl-6310MC, then it is OK because your camera is not equipped with
MMS-module. If it is a MMS Model Ltl-6310MG, you can take out from the battery box one of
the batteries and replace it and re-check the MPNO signal by following the aforementioned
steps.
LTL ACORN®