LSI Symbios SYM53C040, Technical Manual

Page: 111 / 214

Symbios SYM53C040 Enclosure Services Processor Technical Manual 7-1
Chapter 7
Miscellaneous
Registers
This chapter contains descriptions of the SYM53C040 Miscellaneous
registers. The SCSI/DMA registers, SFF-8067 registers, Two-Wire Serial
registers, and System registers are described in
Chapter 4 through
Chapter 7 , and Chapter 8 . The term “set” is used to refer to bits that are
programmed to a binary one, while the terms “reset” or “clear” are used
to refer to bits that are programmed to binary zero. Any bits marked as
reserved should always be written to zero; mask all information read from
them. Reserved bit functions may be changed at any time. Unless
otherwise indicated, all bits in registers are active high, that is, the feature
is enabled by setting the bit. The bottom row of every register diagram
shows the default bit values, which are enabled after the chip is powered
on or reset.
Figure 7.1 summarizes the entire SYM53C040 register set.
Figure 7.1 Register Set Overview
0xFC00
0xFC1F
0xFC20
0xFCFF
0xFD00
0xFDFF
0xFE00
0xFEFF
0xFFFF
0xFF00
System Registers
Miscellaneous Registers
Two-Wire Serial Interface Registers
SFF-8067 Registers
SCSI Core and DMA Registers