LSI Corporation Confidential
|
August 2010
Page 11
MegaRAID LSIiBBU08 Intelligent Battery Backup Unit Quick Installation Guide
Connecting the LSIiBBU08 Remotely to the MegaRAID SAS RAID Controller
NOTE:
Because server and workstation chassis vary from vendor to vendor, no standard
mounting option exists that is compatible with the various system configurations. The
LSIiBBU08 battery kit, in combination with the Remote Battery Kit, includes the battery,
daughtercard, cable, and standoff. This combination enables authorized resellers and
chassis manufacturers to customize the location of the remote battery to provide the
most flexibility within various environments.
Removing the RAID Controller
from the Computer
Follow these steps to remove the RAID controller from the computer.
1. Turn off the power, and unplug the power cords.
2. Ground yourself and make sure the system is grounded.
3. Remove the cover from the computer, according to the instructions in the system
user’s manual, to allow access to the controller.
4. Unplug all cables from the controller, remove the screw attaching the bracket to the
computer chassis, and carefully remove the controller from the slot.
5. Place the controller on a flat, clean, static-free surface, and continue with the next
procedure.
Installing the Interposer Card on
the Controller
Follow these steps to install the interposer card on the controller, as shown in
Figure 6
.
1. With the controller on a flat, clean, static-free surface, ground yourself and make
sure the system is grounded.
2. Remove the interposer card, standoff, and screws from the package.
3. Place the standoff on the controller so that the bottom side is over the screwhole
next to the JT3 BBU connector on the controller.
4. Use one of the screws to secure the standoff to the controller.
CAUTION:
Center the screwdriver carefully to avoid stripping the screwhead. Do not
overtighten the screws.
5. Hold the interposer card so that the J1 board-to-board connector on the interposer
card lines up with the JT3 board-to-board connector on the controller.
6. Carefully press the J1 connector on the interposer card into the JT3 connector on
the controller so that the two connectors are firmly joined.
The connectors fit only when they are in the correct alignment.
7. Use the other screw to secure the interposer card to the controller and continue
with the next procedure.
Summary of Contents for MegaRAID LSIiBBU08
Page 16: ...46307 00A...
