38176-00, Rev. A, May 2008
Find a list of LSI Corporation’s U.S. distributors, international distributors, sales
offices, and design resource centers on the LSI website at:
LSI, the LSI logo design, and MyStorage are trademarks or registered trademarks
of LSI Corporation. All other brand and product names may be trademarks of their
respective companies.
Copyright © 2008 by LSI Corporation. All rights reserved.
LSI Corporation reserves the right to make changes to any products and services
herein at any time without notice. LSI does not assume any responsibility or liability
arising out of the application or use of any product or service described herein,
except as expressly agreed to in writing by LSI; nor does the purchase, lease, or
use of a product or service from LSI convey a license under any patent rights,
copyrights, trademark rights, or any other of the intellectual property rights of LSI
or of third parties.
Step 4
Connect the 12-inch cable from the J5 connector
on the iBBU01 to the J11 battery backup
connector on the backside of the SAS 8344ELP
RAID controller, as shown in
On the iBBU01, pin 1 of J5 is marked by a white
dot. Pin 1 of the cable should be connected to the
white dot on J5.
Note:
The cable connector is polarized and can be
inserted into the J11 board battery connector only
if the rails on the harness connector align with the
slots on the J11 connector.
Do not
force the
cable into the 20-pin in-line connector. The cable
end should insert into the connector with minimal
resistance.
Figure 2 Connecting the iBBU01 to the SAS
8344ELP RAID Controller
D i s p o s i n g o f B a t t e r y B a c k u p U n i t s
Warning:
If the iBBU is damaged in any way, toxic
chemicals may be released.
The material in the battery pack contains heavy metals that
can contaminate the environment. Federal, state, and local
regulations prohibit the disposal of rechargeable batteries in
public landfills. Be sure to recycle the old battery packs
properly. Comply with all applicable battery disposal and
hazardous material handling laws and regulations in the
country or other jurisdiction where you are using the iBBU.
T e c h n i c a l S u p p o r t
For assistance in installing, configuring, or running your SAS
RAID controller, contact LSI Technical Support.
Phone Support:
1-800-633-4545 (North America)
Website:
There is danger of an explosion if the battery is
incorrectly replaced. Replace it only with the
same or equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
WARNING
!
