LSI-Robway RCI-1550 LM, Instruction Manual

Page: 27 / 97

6.7. Menu Navigation
During normal operation the soft menu key with the label “Menu” can be pressed. This will cause the
lower section of the LCD to display the main menu screen.
By pressing the Up/Down soft menu keys the desired menu item can be selected.
The currently selected menu item is highlighted by a solid bar, pressing the OK key will activate the
selected item. The main menu consists of 4 four main sections which are discussed below.
6.7.1.
Config Change Menu
This selection is used when the operator wishes to change some aspect of the crane configuration.
Upon selection of this item the “Config Menu” is displayed. The Config Menu typically allows the
operator to change the following parameters:
 the currently selected duty,
 the falls (parts of line) for each winch,
 any special items for a particular job,
It is not possible to change the crane configuration when a lift is being performed. If the current
load (on any winch) is greater than or equal to the Lift Threshold value (for the given winch), the Lift
in progress screen will be displayed. This inhibits the altering of configuration once a lift has begun.
If it is imperative to change the configuration even though a lift is being monitored, it is possible to
change the duty and or falls in calibration mode provided you have the correct access code.
When no lift is in progress it is possible to change any of the items that describe the crane
configuration.
Selecting to change the duty will cause a series of screens to be displayed prompting the operator
to select each aspect of the current crane configuration.
Once editing is complete, pressing the OK button changes the duty according to the selections
made, if possible, else a message is displayed informing the operator that there is no duty provided
that matches the selections made.
Selecting to change the falls will bring up the falls change screen, provided that no lift is currently in
progress. This screen allows the operator to set the currently reeved falls
for the currently selected
winch
.
The falls can be changed by either using the Up/Down keys or by using the numeric buttons. Once
editing has been complete, pressing the OK button effects the change to the new edited value. If
the cancel button is pressed the edit is discarded and the display returns to the main menu.
6.7.2.
Function Codes
Refer to the Function listing at the rear of the manual for detailed information on the available
function codes.