SYSTEM SETTINGS
Setting the Vibration Mode
Vibration mode determines the number of times a pager will vibrate when paged.
NOTE:
The factory default setting for vibration mode is 1 vibration. (EX: When a page is sent from
the transmitter, the pager will vibrate once)
To set the vibration mode, use the following steps:
• 1 vibration: Press PROG
Enter 9 - 2 - 1 and press ENTER
• 2 vibrations: Press PROG
Enter 9 - 2 - 2 and press ENTER
• 3 vibrations: Press PROG
Enter 9 - 2 - 3 and press ENTER
• Page a pager (see pg. 6) to ensure that the pager vibrates the number of times programmed
System Reset
If the transmitter’s battery has been completely depleted, it may require a system reset before operating
properly. When the system is reset, the Restaurant ID (see pg. 7) and vibration mode (see pg. 7) will be set
to factory default.
To reset the transmitter to factory default:
1. Press PROG
2. Enter 0 - 0 - 0 and press ENTER
Set Restaurant ID
NOTE:
The T9550 LCK is shipped factory defaulted in the most commonly used configuration.
• The Restaurant ID factory default setting is 0.
Your system may or may not be shipped with the factory default setting ID = 0. However, this ID# is often used,
except in cases where neighboring establishments both use LRS systems and would interfere with each
other. Contact LRS to verify your Restaurant ID. (It is not recommanded to change system ID without speak-
ing to LRS service departments.)
To change the ID:
1. Press PROG
2. Enter 9 - 0 - # (EX: 9 – 0 – 3, Restaurant ID = 3)
3. Press ENTER
Long Range Systems
6
T9550 LCK User Manual
