11. Replace the battery and wait for the screen display to go blank (wait about 10 seconds).
12. Press
Program
to program the pager. A message box will appear to indicate programming.
13. The pager will beep four times to indicate it is being programmed. Programming is complete
when the pager stops beeping.
14. Repeat steps 4-6 to program any additional pagers.
Troubleshooting
In order for your Button Butler to alert a pager, the Button Butler must be programmed on the same System
ID as the pager, and the pager number must be programmed into the Button Butler.
To verify the pager’s System ID:
1. Remove the battery from the pager
2. Reinsert the battery and read the display.
Example:
If Pager Number = 1, Page All = 911, System ID = 0
The display will read:
• C1: [0]1 Pager Number (1)
• C2: [0]911 Page All (911)
• C3: [0]0 System ID (0)
To verify the Button Butler’s System ID:
1. Plug one end of the USB to the PC and the other end to the Button Butler.
2. Open the
Butler Configurations Utility.
3. Click the
Read Butler button.
4. The current system ID will be displayed under
System ID
Long Range Systems
11
Button Butler Program Guide
