LP Archery Products
LP Archery Products
Due to universal design, some technical
ability is required for proper installation.
NO Kit/Install Instructions for Sure-LOC S2 Scope.
Package Contents
Digital Power Pack w/ (2) 2032 Batteries
Velcro or Velcro/Hardware Mounting Kit
Tubing Adaptor, .094 Tube to 8-32 Hole
Operating and Mounting Instructions
8-32
24” Fiber
(Dia. & Color Checked Below)
Pwr/Cntrl Pack is NOT 100% Water Proof. Cover Pack w/ EXWC in Extremely Heavy Rain.
EXWC=Extreme Weather Cover (Included w/ Kits or available thru LP Archery)
1. Screw SPL Brass into tapped hole and tighten firmly with fingers. For install into a competi-
tion scope and/or adding a tapped hole into a scope or sight, see Comp. Scope Installation.
2.
Bend wires to one side of SPL Brass and press on black rubber cap for maximum
protection or secure with Zip tie around SPL. See pictures below.
Allow wires to hang.
3. Determine location for Power/Control Pack (see pictures below or pg. 4).
4. Alcohol wipe an area a Velcro pad may be placed on bow or sight.
Wipe dry with paper towel or allow to air dry.
5. Remove hard Velcro pad from soft Velcro pad on back of P/C pack. Peel backing off hard
Velcro pad & adhere to pre-determined alcohol wiped location. Press firmly for 20 seconds.
Trim pad to fit if needed.
6. Remove screw from top side of P/C Pack & separate halves. Insert a battery into each bat-
tery holder with positive side facing upward. Replace cover and Phillips screw onto base.
7. Align soft Velcro Pad on P/C Pack with hard Velcro pad & press firmly.
8. Adhere a
second
hard Velcro pad (trim to fit) to opposite side of sight bar or bow riser.
Velcro straps should wrap over second hard Velcro pad and Power Control Pack to ensure
maximum P/C Pack stability.
9. Plug SPL wire into P/C Pack. For competition setups use top port; for hunting sights use
bottom port.
10. Run SPL wire along sight/scope housing and secure with Zip ties or extra Velcro strapping.
Allow necessary slack in SPL wire for yardage adjusting. See pictures opposite page.
Sight Pin Light (LED Assy.) & Power/Control Pack Installation:
Power/Control Pack Mounting Pictures: Competition Sight
Sight Pin Light (SPL/LED Assy) Mounting Pictures
INSTALLATION INSTRUCTIONS
Not Following Instructions May Cause
Product Failure &/or Void Warranty
Additional Set of (2) 2032 Batteries
EXTREMELY IMPORTANT: SEE PICS BELOW & STEP 2 ABOVE
**NOT DOING STEP 2 WILL CAUSE LED FAILURE**
Sight-Pin Light - Blue, (Threaded)
Ultimate Sight Pin Illuminator
Alcohol wipe both sides of sight bar, and apply
Velcro pads to BOTH sides. Trim as needed.
P-1
Tubing, 2 x 8” - .086 OD & .094 OD
Clear
Blue
Yellow
PLDX2 Multi-Pin Sight Kits &
All PLK Accessories Also Available
Contact LPA or your local Dealer
Digital Light Kit for Competition Scopes
LIMITED 1 YEAR WARRANTY
WITH VALID PROOF OF PURCHASE
(This Kit not designed for use w/ Axcel Scopes)
For Axcel Scopes w/ Axcel Sight use: PLK-AXL-1019B
Green
Red
Hunter Orange
.010
.015
.029
.019