3
are 4mm x 30mm. (about 1 1/8” long). Drill 4.75 mm (3/16”) holes for the
mounting screws. If you're installing the LGC-12S, and need to route the
cable through the mounting surface, you’ll need to drill a 25 mm (1”) hole
for the cable's connector. There is a notch in the antenna housing that
allows the cable to pass through to the outside, if desired, instead of rout-
ing it through the mounting surface.
After drilling the holes, pass the o-ring over the cable and press it into the
groove on the bottom of the antenna housing. Now attach the antenna to
the mounting surface, using 4mm screws and the supplied lock washers.
Route the cable and the GPS module installation is finished.
GPS MODULE TEMPLATE
25MM (1”)
(If Necessary)
4.75MM (3/16”)
4 PLACES
Summary of Contents for LGC-12S
Page 1: ...1 OWNER S MANUAL ...
