| 13
Wiring |
HDS Gen3 Polaris Installation Manual
Wiring
Guidelines
Do not do this
Do this
Do not make sharp bends in
the cables
Do make drip and service loops
Do not run cables in a way that
allows water to flow down into
the connectors
Do cable tie all cables to keep
them secure
Do not route the data cables
in areas adjacent to radar,
transmitter, or large current
carrying cables
Do solder/crimp and insulate all
wiring connections, if extending
or shortening power or NMEA
0183 cables
Do leave room at the back to
install and remove cables
!
Warning:
Before starting the installation, be sure to turn
electrical power off. If power is left on or turned on during the
installation, fire, electrical shock, or other serious injury may occur.
Be sure that the voltage of the power supply is compatible with
the HDS Gen3 Polaris display
!
Warning:
The HDS Gen3 Polaris has a voltage rating of 12 V
DC, it is not suited for use with 24V DC systems.
!
Warning:
The positive supply wire (red) should always be
connected to (+) DC with the supplied fuse or a circuit breaker
(closest available to fuse rating).
4
Summary of Contents for HDS Gen3 Polaris
Page 1: ...ENGLISH HDSGen3Polaris Installation manual polaris com by Lowrance ...
Page 2: ......
Page 44: ... 988 10952 001 0980 ...
