6
MOUNTING THE TRANSDUCER
1. Slip the washer onto the transducer rod, followed by the transducer and
the wing nut.
Assembled transducer, attached to the mounting rod.
2. The wing nut should be tightened enough to hold the transducer on the
rod, but it should be loose enough to allow the transducer to swing freely.
This allows the transducer to self-position itself straight down, for ideal ice
fishing performance.
3. Grasp the assembled transducer and rod in one hand and thread the
swing arm's socket end onto the rod.
Insert mounting rod through swing arm's socket, as shown.
4. Snap the red rubber adjustment lock onto the rod and screw it into the
swing arm's threaded socket. As the lock is screwed in, it tightens on the
mounting rod, holding it in place.
