SUMMARY
Please check that wiring and power connections conform to the above instructions. In the event of a malfunction, refer to
the troubleshooting guide, next page. Should the problem persist, factory assistance is available from 8:00 AM to 4:00
PM (Pacific Time) by calling (818) 994-6498.
OPERATION AND TEST
After microphones and power supply are connected, proceed as follows:
1)
Turn on power to the unit by rotating the Power-Volume Knob
[8]
clockwise to “ON” position. The green LED
[2]
will illuminate, indicating power to the unit. Rotate Power-Volume Knob further clockwise to increase the
volume of monitored audio.
2)
Press Zone Selector Switch
[1]
marked zone 1. Audio from zone 1 should be present at the Monitor
Speaker
[10]
. If there is no audio, remove wires connected to Mic Input 3-Pin Terminal Block
[12]
for zone 1
at the rear of the unit. With a DC voltmeter, check that 12 Vdc is present at terminals “A” and “C”. If voltage
is not present, unit has defective regulator. If voltage is present, check to assure that wires are connected
properly to the right terminals. Otherwise microphone is defective. Call factory for assistance.
3)
Repeat step 2 for the remainder of the zones.
4)
When a recorder is connected to the unit, press DVR/VCR-IN Switch
[7]
. DVR/VCR-IN indicator
[4]
will light.
Start recording live audio. The DVR/VCR-IN Switch
[7]
must be depressed or in the “OUT” position when a
recorder is not connected to the unit.
5)
Playback recorded audio through the AP-4, etc. built-in amplifier and speaker.
INSTALLATION AND OPERATING INSTRUCTIONS
Page 6 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
®
ask4_104_inst_12/11
