MICROPHONE CONNECTIONS TO AP-4
A 12Vdc power supply is included with the above units. First connect the small end with the 90° plug to the above
units DC Jack
[11]
and connect large end to a standard 120Vac outlet or power strip.
Maximum distance between AP-4, etc. and Louroe microphones is 1,000 ft. (305m)
CONNECTING AP-4 TO A RECORDING DEVICE (DVR, ETC.)
All Louroe Verifact™ Microphones contain a 3-pin terminal block marked A, B, C. All Louroe base stations contain similar
3-pin terminal blocks marked A, B, C. Refer to interconnection diagram p 5.
A = 12Vdc Power (red wire)
B = Audio Output (black wire)
C = Common Ground (bare wire)
1) Take one end of recommended cable to first microphone location and connect:
Red wire to terminal A (12Vdc)
Black wire to terminal B (Audio Output)
Bare wire to terminal C (Ground)
2) Run other end of cable to the AP-4 Base Station location and connect to the 3-pin terminal block of the audio
zone in which the remote microphone is assigned (example zone 1). Again connect Red wire to Pin A, Black
wire to Pin B and Bare wire to Pin C.
3) Repeat the same procedure for the remaining microphones using the additional terminal blocks marked zone
2, zone 3, etc.
A) If connecting to a VCR or to a DVR with one audio input:
1) Connect an RCA cable to the Audio Out jack
[13]
of AP-2 and connect other end to Audio In (or line
in) of VCR/DVR
2) To record, press the Zone Selector Switch
[1]
located on front panel of base station for the audio zone
to be recorded
3) For audio playback, connect another RCA cable from Audio Out (or line out) of VCR/DVR to Audio In
[14]
of AP-4
4) Press in the VCR Button
[7]
of front panel
5) Press the play or playback button on VCR/DVR to start audio playback. Playback will be broadcast
through the base station’s built-in speaker. As an alternate playback may be channeled through a
CCTV monitor with amplifier or through DVR’s speaker system
2) If connecting to a DVR with multiple audio inputs or to a soundcard module:
AP-4 has 2 line level RCA Mic Output Jacks
[15]
1) Connect RCA cables between the Mic Output Jacks
[15]
and Audio Inputs of DVR
2) For audio playback from base station (AP-4, etc.), press in the VCR IN button
[7]
located on base
station’s front panel. Playback may also be channeled through other audio sources
3) To select a specific audio zone for playback, refer to DVR’s instruction manual
APPLYING POWER TO THE AP-4
INSTALLATION AND OPERATING INSTRUCTIONS
Page 4 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
®
ask4_104_inst_12/11
