Seite 9 / 10
Operating Instructions
LTS 138 b + LTS 150 b
9. Maintenance
Following the safety directions mentioned below is essential to avoid severe in-
juries to the operator and/or damage to the transfer press.
Before performing any maintenance work, the transfer press must have been switched
off and the plug must have been removed from the power socket.
Note the high temperatures of the top heating plate. It can take up to 15 minutes until
the plate has cooled down to a temperature below 50° C.
Carefully follow the instructions mentioned in this manual before performing any
maintenance or cleaning work on the transfer press.
Maintenance work must only be performed by skilled and specially trained staff.
Before switching on the unit again after maintenance or cleaning work, ensure that no
tools or spare parts have been left in or on the unit and that shrouds, safety applianc-
es, graphic symbols and instructions attached to the press are in good condition and
easy to read.
10. Dismantling and Disposal of the Transfer Press
All work for dismantling or disposal must be performed by sufficiently qualified
staff.
A transfer press is an industrial unit. All applicable laws must be followed concerning
the disposal of industrial machinery in the country of the user.
Disconnect the unit from the power supply and dismantle it. Sort the parts according to
their composition, e.g. aluminium, plastic, steel, mineral wool etc. The disposal of the-
se material groups must be performed in accordance to the applicable laws in the
country of the user.
Strictly follow the safety instructions mentioned in this manual when dismantling the
press.
