Output
from
Air
Compressor
Argon
Gas
Figure 1.5
Gas
Inlet
15-20
min/L
Argon
Regulator
Figure 1.6
Machine
Air
Compressor
Figure 1.7
a) If you switch from plasma cutting to TIG welding quite often,
consider buying a LOTOS 3 way valve kit to connect both the
argon tank (Figure 1.7) and the air compressor simultaneously.
- Connect your TIG torch and ground cable to the front panel of the machine.
- Make sure the ground cable is connected on the right hand side where the “+” sign is located
- Set TIG Weld/Stick Weld/Plasma Cut to TIG Weld mode (refer to Figure 1.4, page 2)
- Set “2.5S/5S” to “2.5S” mode.
- Set “Machine/PEDAL” to “Machine” mode.
- Adjust current dial from 10 to 200 amps (Figure 1.8).
TIG
Torch
Output
Figure 1.8
5-pin
Switch
Plug
3