11
v
OUTPUT CONNECTIONS
ELECTRIC SHOCK can be fatal
w
Keep the plasma cutting torch and ground cable & clamp in good condition and in safe
place.
w
Do not touch electrically live parts with skin or wet clothing.
w
Insulate yourself from work pieces.
w
Turn the machine “off” before connecting or disconnecting output cables or other
equipment.
Ø
GAS CONNECTION
Ø
CONSUMABLES INSTALLATION
The consumables set of electrode, nozzle and cup should install in
order as shown in Figure A.2.
The LTP8000 can only use genuine LOTOS brand consumables sets
of BCON serial.
One set of consumables has already been installed in the torch head.
CYLINDER could explode if damaged
w
Keep cylinder upright and chained to a support.
w
Keep cylinder away from areas where it could be
damaged.
w
Never allow the torch or welding electrode to
touch the cylinder.
w
Keep cylinder away from live electrical circuits.
Obtain the necessary air. Connect the cylinder of compressed air or
air compressor with a pressure regulator and flow gage. Connect the
quick connector couple from your air compressor to the plug
(Industrial Type D 1/4” NTP) located on the rear of the plasma cutter.
The installed rear is shown in Figure A.1.
Air
Compressor
Air Compressor's Female Coupler
