®
b) If you want to dynamically control the welding heat, please use a foot pedal (not included in the
box. To purchase, please go to our website). Then connect the “on/off” connector to your foot
pedal and leave the wire of the TIG torch unplugged.
- Set TIG Weld/Stick Weld/Plasma Cut switch to TIG Weld mode (refer to Figure 1.4, page 2).
- Set “2.5S/5S” to “2.5S” mode.
- Set “Machine/PEDAL” to “Pedal” mode.
- Adjust current dial between 10 and 200 Amp (Figure 1.9).
3. TIG torch head parts (Figure 1.10) and assembly (Figure 1.11)
(The tungsten is not included in the picture; please buy proper DC Lotos tungsten electrodes.)
Grind and sharpen the tungsten before first use.
Figure 1.9
Figure 1.10
Figure 1.11
Foot
Pedal
with
Amp Adjusts
Ground
Cable
5-pin
Foot Pedal
Plug
TIG Torch
Output
Unplugged
4
