O R E N Z
P U L S E 5
27
Coil-jack
Searchcoils of different size and shape can be
connected to this jack. The searchcoils available
for the LORENZ PULSE 5 have got coded connectors
to adapt the electronics to the coil automatically.
With the same connector the power supply can be
interrupted when disconnecting the coil plug from
the coil-jack. The built-in rechargeable battery
therefore can't be discharged in this case even if
the LORENZ PULSE 5 is turned on. To connect a
coil plug to the electronics make sure that the plug
is fully pushed in the jack and that the sleeve is
fastened by roating it clockwise.
Note:
Any connectors should be disconnected
from the rear-panel when planning to store the
LORENZ PULSE 5.
Headphone-jack
The supplied stereo headphones can be connected
to this jack. Any stereo headphones with
1/4 inch (6,35 mm) plugs can be connected to the
LORENZ PULSE 5 without any problems.
The built-in loudspeaker will be automatically
turned off when headphones are connected.
Note:
Special Headphone-adaptor plugs have to
be disconnected when using the Loudspeaker.
Loudspeaker
The LORENZ PULSE 5 has got a built-in loudspeaker
on the rear-panel which gives an audible signal
when the searchcoil approaches to a metal object.
The audio frequency will change with the distance
between the searchcoil and target for better
pinpointing. Especially with two persons operation
and large diameter coils the signal from the
loudspeaker is of greater help for both persons.
Charger / Ext. power Jack
To this connector the supplied charger can be
connected in order to recharge the built-in Batteries.
It is also possible to connect additional battery packs
to increase the operation time of the detector to up
to 24 hours. To connect the recharger or an
additional Battery pack simply plug in the connector
and fasten the metal sleeve of the plug clockwise
(see chapter 7 for more detailed information.)
3.2. Connectors on the rear panel
Red battery-indicator-light
This light indicates that the battery is discharged.
During operation this light must be off. The LP 5
has to be turned off when this light comes on.
Blue discriminator-light
This light will always turn on when a conductivity
meter reading will be stored as long as the
searchcoil is in the near of the detected target.
Note:
The discriminator-ligth will turn on even in
position 1, 2, 3 although no target classification
is possible in those mode-positions.
