LORCH MobilePower 1, Operation Manual

Page: 15 / 84

Messages, fault rectification
909.2099.9-02 - 15 -
06.15
8 Messages, fault rectification
8.1 Welding operation
Flash code Error Rectification
Charge condition indica-
tor (3)
The first LED
flashes green/
yellow alter-
nately
Welder not connected to the
battery
Connect battery to welder at the lat-
est within 15 seconds of button on
The first LED
flashes yellow
The battery is flat, further work -
ing is not possible
The battery needs charging
The first LED
shows constant
yellow
Reserve operation: Continued
working is possible
Charge the battery after 1-2 elec-
trodes
Fault indicator (8)
Continuous light Cell temperature too high
Allow the battery to cool down and
then operate at the correct operating
temperature
1x flash Over-current error on welder Replace the welder or consult the
service department
2x flashes Cell temperature too low Operate in the correct range of
operating temperatures
3x flashes Cell over-voltage Consult service department
4x flashes Cell under-voltage Connect the battery to the charger or
consult service department
5x flashes Error voltage at the casing Consult service department
6x flashes Cell voltage differences Consult service department
7x flashes
8x flashes
Electronic fault Consult service department
8.2 Charging the battery
Flash code Error Rectification
Charge condition indica-
tor (3)
The first LED
flashes green/
yellow alter-
nately
No charging current
Check the charger or consult the
service department
Fault indicator (8)
Continuous light Cell temperature too high:
Allow the battery to cool down and
then operate at the correct operating
temperature
2x flashes Cell temperature too low
Operate in the correct range of
operating temperatures
3x flashes Cell over-voltage Consult service department
4x flashes Cell under-voltage Consult service department
6x flashes Cell voltage differences Consult service department