Basic controls
In the main view (the LCD shows the indicators), the power setting device
can be adjusted in five steps using the up / down arrows and seven-level
LCD brightness control, using the left / right arrows. At the lowest level,
only a dash appears in the display, the individual indicators are gradually
displayed up to full brightness. At the very highest level, the frame itself
(Lightloop) lights up if it is set in the menu.
When you press the OK buttons in the main view, the Configuration menu
appears. Here you can set the frequency generator, LightLoop, language
and display service device information.
The device has an auto-off function. If it is not operated by the keypad,
generating is not running, or if there is no signal from the external
generator, it is automatically switched off after 15 minutes.
If you need to reset the factory settings or if the device is behaving
contrary to the instructions, you can reset it by holding the OK + Down
arrow buttons until the RaMaLoop logo appears on the display.
LightLoop settings
LighLoop has three basic settings: Off, RGB, and Optional Color.
The "Off" setting switches off the lights.
The "RGB" setting starts the automatic color change. The rate of change can be
set using the "Change Speed" item in the RGB setting. The "Modulation" option
allows you to set the flashing of the illumination in the rhythm of the input
pulses, the blinking is only visible up to 50Hz, it is permanently lit at higher
frequencies.
The "Optional Color" setting starts the user-adjustable color illumination. The
resulting color is given by "Red Level", "Green Level", and "Blue Level".
Setting the LighLoop antenna lighting has no effect on electromagnetic field
generating. When the generator is switched on or an external generator is
connected, the electromagnetic field is emitted by the antenna without being
switched on or off by LighLoop lighting.