9
5. Operating the Tiny FX
5.2 Mounting the Tiny FX
5.3 Starting up
If the
Tiny FX
is to be built in props or similar, make sure that a fog-free air supply
is guaranteed. Too high a fog concentration can condense inside the machine and can
result in damages caused by moisture.
When installing the
Tiny FX
make sure that
• no fog is passed back into the fog generator,
• no condensed fluid runs into the apparatus,
• the air vents [1] are not covered or concealed,
• no objects protrude into the fog nozzle [2]. This may destroy the vaporizer.
a) Remove both covers from the already filled fluid reservoir. Screw the reservoir into
the
Tiny FX
.
The covers should be stored. The reservoirs can be refilled with the delivered refilling
set and can be used several times. Check the cleanliness, so that no dirt (fluff etc.) can
be sucked in by the pump. Even the smallest impurity immediately leads to clogging
of the machine.
b) Connect the machine and the battery-pack to the battery cable, using the right
sockets. The yellow LED [5] will start to flash.
c) Press and hold the start button in the lid of the machine [4]. After approx. 1 second
the unit generates fog as long as the button is hold.
If you would like to control the machine via the cable remote or radio remote, connect
the control cable for the remote or the receiver of the radio remote to the machine.
You can start the fogging process by pressing the start button at the cable remote
or radio remote.
Caution
: Do not put anything into the fog nozzle. This may destroy the vaporizer and
it then has to be changed (see point 8.1)
If the
Tiny FX
is not generating fog, the machine switches off automatically after
approx. 1 minute. The yellow LED [5] does not light anymore. The machine can still be
activated at any time by pressing the start button in the machines lid, the cable remote
or the radio remote.
