9
a) Open the receiver by removing the cover plate. This is only snapped together
and can usually be taken off without any tool. A slim slot screwdriver also
enables you to remove the cover.
b) Connect the receiver to the machine.
c) To start the configuration, press the black Configuration-button [1] briefly.
The yellow LED [2] flashes.
Press the button on the transmitter that shall be configured. If the configu-
ration is successful, the yellow LED [2] lights up permanently.
The connected machine will now run as long as the configured button at the
transmitter is held down.
The procedure can now be repeated if the configuration of further buttons is
required for the same receiver. Up to six buttons can be saved for one receiver. If
more then six buttons are configured, the previous configurations will be
overwritten.
You can configure several receivers on the same button. All receivers will then
be activated at the same time and for the same running period.
If the receivers should react on different buttons, repeat the above mentioned
procedure for each receiver, always configuring a different button at the trans-
mitter as the Start-button.
3.2.2 Configure the buttons in the Standard-Mode “Press and release“
The transmitter will be delivered with the first button pre-programmed as the
Start-button. The machine will run as long as this button is held down.
Please note
: All pre-programmed configurations (button 1 = Start-button) should
be deleted (see point 3.3) before you start to configure the other buttons, unless
you want to use the first button as a Start-button.
Receiver as it looks in the Standard-Mode
(red Jumper in original position)
[1] black Configuration-button
[2] yellow LED
[3] red Jumper
3. The Receiver
Summary of Contents for Radio Remote
Page 1: ...1 Operating manual Radio Remote v 2 0 a Look Solutions product ...
Page 15: ...15 ...
Page 16: ...16 a Look Solutions product ...