Look Solutions Radio Remote, Operating Manual

Page: 10 / 16

10
3.2.3 Configure the buttons in the “On/Off“-Mode
3. The Receiver
a) Open the receiver by removing the cover plate. This is only snapped together
and can usually be taken off without any tool. A slim slot screwdriver also
enables you to remove the cover.
b) Remove the red Jumper [3]. To avoid the loss of the Jumper, replace it shifted
in a way, that one of the legs will stay uncovered as shown above.
c) Connect the receiver to the machine.
d) To start the configuration, press the black Configuration-button [1] briefly.
The yellow LED [2] flashes. Press the button at the transmitter that shall be
configured. If the configuration is successful, the yellow LED [2] lights up
permanently. The connected machine can now be deactivated with the
configured button.
The receiver changes into the On/Off-Mode by changing the position of the red
Jumper [3].
Those buttons already configured in the Standard-Mode will automatically be
recognized as Start-buttons. Buttons configured in the On/Off-Mode will be Stop-
buttons.
Therefore, the machine can be activated by pressing the configured Start-button
briefly. It is not neccessary to hold the button constantly. The configured Stop-
button can be pressed briefly to deactivate the machine.
Please note : The red Jumper [3] must be placed shifted for the On/Off-Mode to
remain activated. As soon as the red Jumper is replaced to its original position,
the Standard-Mode (Press and release) will automatically be re-activated!
This deactivates the configuration of the Stop-buttons but does not delete their
function. As soon as the Jumper is placed shifted again, the configured Stop-
buttons are reactivated.
Receiver as it looks in the „On / Off“-Mode
(Red Jumper shifted)
[1] black Configuration-button [2] yellow LED
[3] red Jumper