Look Solutions Radio Remote, Operating Manual

Page: 4 / 16

4
1. Introduction
The UHF radio system consists of a radio transmitter and one or several receivers.
The operating frequency of the system is 433.92 MHz.
The radio remote has two different Modes, which can be changed easily
whenever neccessary (see point 3.2.3):
In the Standard-Mode “Press and release“ the machine will be triggered to run
as long as the button is held down. If the button is released, the machine will
stop working.
In the “On / Off“-Mode, the machine will be activated by pressing the pro-
grammed Start-button shortly and deactivated by pressing the programmed Stop-
button.
The radio transmitter allows you to address four channels which can either be
four individual receivers or four receiving groups. The number of the receivers
per channel is not limited.
One receiver can save up to six configurations. The “On“- and “Off“-buttons
can be also configurated.
Thus, the permanent pressing of the button at the transmitter is no longer
neccessary. The machine can now be activated by pressing button 1 briefly and
can be deactivated by pressing button 3, depending on which buttons have been
configured.
The transmitter of the original Look radio remote is compatible with the new
receivers.
The receiver of the original is incompatible with the new transmitter!
The transmitter is supplied with the first button pre-programmed, allowing
the radio remote to be used immediately.