Cell Phone Paging
Overview
The Cell Phone interface is used to extend the capability of the on-premise paging system.
When a Guest’s Cell Phone number is entered, the transmitter will store the number as a Pager Number be-
tween 500 and 599.
System Requirements
Cell Phone Paging requires broadband internet service, a CAT-5 Ethernet cable, and an activated account
with Long Range Systems.
Two Steps to enable the Cell Phone Paging:
Step 1
1. Disconnect power to the T7460.
2. Connect the CAT-5 cable to the Ethernet port.
3. Re-connect power to the T7460.
4. Press SETUP and enter Password.
5. Press 1) System.
6. Press 2) Cell Phone Paging.
7. Press 1) Enabled.
8. When asked to Enable voice/SMS paging, press F1 (Yes) or F4 (No).
9. Exit.
Step 2
1. Press SETUP and enter Password.
2. Press 3) Other.
3. Press F2 (Down).
4. Press 3) Network.
5. Press 1) Enabled.
6. Press F1 (Yes) to enable or press F4 (No) to disable Network.
For Users on DHCP Network
From Network Menu
1. Press 2) DHCP.
2. At prompt Use DHCP, press F1 (Yes).
For Users on Static Network
For users on a Static Network, the user will need a valid IP Address available on their internal network.
Contact your local Network Administrator for an available IP address.
Note:
If an IP Address has one or two digits, the address must be written out fully (example
192.168.7.17 must be entered 192.168.007.017.)
From Network Menu.
1. Press 2) DHCP.
2. At prompt USE DHCP, press F4 (No).
3. Press 3) IP.
Long Range Systems
25
Freedom User Manual
