4. Press 1 (1: POCSAG).
5. Press F2(DN) until 2)POCSAG Start is displayed.
6. Press 2) POCSAG Start.
7. For Guest Alphanumeric Pagers, press 1) Guest and type in the new POCSAG start number from 1 –
9999.
8. For Staff Alphanumeric Pagers, press 2) Staff and type in the new POCSAG start number 1-9999.
Choose number from 1 – 9999. Press ENTER to keep a default value - 50.
Station ID
Station ID is often confused with System ID. This function is used where more than one station of the same
establishment may be paging staff pagers. The indicators on the pager will show this code.
To set a different station number:
1. Press SETUP and enter Password.
2. Press 1) System.
3. Press F2 (DN) until the display shows 3) Station ID.
5. Press 3 (3: Station ID).
6. The display shows the current station ID number (default is 1).
7. Press a number to use (0 – 9) to change the default Station ID number and press ENTER.
Adjust Transmit Power
The range may be increased or decreased from the transmitter by adjusting the transmit power level. The
power levels are 1 through 5.
Default from the factory is power level 3. Reset only by direction from LRS.
To set the power level:
1. Press SETUP and enter Password.
2. Press 1) System, press F2 (DN) until the display shows 2) Transmit Power.
5. Press 2 (2:Transmit Power).
6. Set the required power level (from 1 through 5).
7. Press ENTER.
Locating Misplaced Pagers
Two location modes are available for finding lost or misplaced pagers/coasters. Auto Locate Mode auto-
matically searches at a preset time, Run Locate Mode searches on demand.
CAUTION:
Do not set auto locate to run or use Run Locate feature while pagers are handed
out. All pagers will be paged!
Auto Locate Mode
Auto Locate sends a signal to ALL coasters/pagers at a preset time. The coasters/pagers will beep so that staff
can locate them.
Example:
If closing at 11:30PM, the transmitter can be set to auto locate at 12:30AM, causing all miss-
ing coasters/pagers to beep at that time.
!
Long Range Systems
23
Freedom User Manual
