Operating instructions
ScanAfia X TK, S, ICU Version 1.5
Copyright © Lojer Oy, 2015
17
The hand-held control is activated by pulling a magnetic key once over the
locking symbol on the control, which turns the locking symbol light green. This
gives access to normal functions: the adjustment of height, backrest and leg
rest. This activates the hand-held control into a so-called patient operation
mode, i.e. all other operations work except the Trendelenburg. Pulling the key
again over the locking point activates the Trendelenburg function. The locking
light turns orange, NOTE! Never leave a hand-held control in this mode within
the reach of an unsupervised patient. The Trendelenburg mode deactivates
automatically after approximately 40 s if the hand-held control is inactive. After
this, the hand-held control can be reactivated in patient operation mode by using
the locking key.
The ICU models usually have a nurse's control board as standard equipment; it
can be used to control the bed just like the hand-held control. Read section '7.6
Operation of nurse's control board' below in this document.
For safety reasons, the beds equipped with a battery have either the nurse's
locking board or the nurse's control board as standard equipment. Read more
about their operation below in these operating instructions (Operating
instructions chapters 7.6 and 7.7).
IMPORTANT!
The appearance of and the order of buttons on the hand-held
controls may vary depending on the model.
IMPORTANT!
If the hand-held control is within the reach of the patient,
operating it may cause danger to the patient or others so we
recommend that the operations of the hand-held control are
locked.
IMPORTANT!
Never leave a hand-held control in Trendelenburg operating
mode within reach of an unsupervised patient. Make sure the
hand-held control is in locked or patient operation mode.
IMPORTANT!
Keep the magnetic key in a safe place, inaccessible to
persons who are not healthcare professionals.
IMPORTANT!
Release the pushbutton of the hand-held control to stop any
movement of the bed. In case of malfunction, press the
pushbutton of a reverse movement in the hand-held control or
nurse's control board to stop a movement for the as long as
the button is pushed. The movement can also be stopped by
locking the function in the nurse's locking board or control
board. The movement of beds without a battery can be
stopped by unplugging the bed's power cable.
IMPORTANT!
Do not press two or more pushbuttons of the hand-held
control at the same time when adjusting the bed.