8
18.06.2012
Rev. 1.0
5.4
Shoulder rotation trainer (accessory)
Shoulder rotation trainer is to be installed to that end of the Lojer 3-section bench where you can find the castors.
Install the device as seen in the Figure 9.
Figure 9: Shoulder rotation trainer
1
Height adjustment
2
Angle adjustment lever
3
Lenght adjustment of the hand support
Adjust height by loosening the screw (1). Tighten the knob when the device is on desired height. Loosen the angle
adjustment lever (2) and adjust the angle to desired position. Adjust the lenght of the hand support according to the
lenght of the arm. Loosen the screw (3), adjust the lenght and tighten the screw.
The product code: KT8163
Make sure that the screws are properly tightened.
Do not use the device with out instructions and supervision of the healthcare professional.
6
Cleaning
Clean the different sections of the device with a moist cloth and mild general purpose cleaning agent, for example,
Desiplint (dilution ration 1:10). The Desiplint cleaning agent is suitable also for cleaning all leather upholstery of other
training devices.
Do not place steam packs on the surfaces since the heat may damage the upholstery.
7
Maintenance
Keep record of all service measures.
Maintenance can be carried out only by authorized service personnel.
Inspect the device regularly. Do not use if the component is found worn or damaged.
If the device makes abnormal noises or does not function correctly, perform the maintenance measures without delay
and/or contact the distributor's maintenance service.
Figure 9: Shoulder rotation trainer
