WDU
WOOD DRYING UNIT
7
MAINTENANCE
The parts of the drying unit can be attacked by corrosion.
Some sorts of wood are more corrosive than others. The
fan wheel (A8), the heater and the heater bracket (A9)
are parts that will be worn by corrosion and have to be
replaced after a period of time.
After every fifth drying cycle or as needed:
• Cut the power.
• Remove the drying unit from the drying chamber.
• Open the front grille (A4).
• Check that the fan wheel and the heater are not
damaged by corrosion. If that is the case, replace
damaged parts.
• Check that the fan wheel can rotate freely.
• If necessary, clean the heater (A9) and the fan wheel
(A8) with a soft brush, soap and water.
• Make sure all water has dried before reinstalling
the grille (A4) and restoring the WDU to its original
design.
• Check that the motor and its external cooling fan are
clean. Remove any dirt.
• Only use original spareparts, attachments or
accessories that are supplied by Logosol or that are
specifically approved by Logosol for the purpose.
After service,
the drying unit
has to be restored
to its original design
. All parts have to be correctly
installed before the drying unit is taken into use.
