6
START
1.
Open the fuel valve by moving the fuel control
lever to the right until it reaches the position ”ON”.
2.
To start a cold engine, move the choke control
lever to closed position (the control lever in its left
position). To start a hot engine, leave the choke
control lever in its open position (the control lever in
its right position).
3.
Turn the ignition key to the ”ON” position and
start the engine with the key.
4.
With the software running, press the start button
at the same time as the enabling switch button is
being pressed down.
5.
This brings the engine up to its operating speed
and the band blade starts rotating.
6.
If the choke is in its closed position, gradually
move the control lever towards its open position as
the enging gets hotter.
STOP
You stop the band blade by releasing the control
lever or the enabling switch button. Then the band
blade will stop and the engine will go to idle. After
that, turn off the engine by turning the ignition key
to the”OFF” position, and then close the fuel valve.
EMERGENCY STOP
Activate the emergency stop by pressing the
emergency stop button. The emergency stop has to
be reset after it has been used.
START AND STOP
