logitrans PANTHER MAXI AC, Manual

Page: 22 / 28

22
7.0 Fault location key
7.1 Remedy
1) Check that the key (1) is turned clockwise and that emergency stop (2) is
not activivated.
2) Charge battery - for charging see instructions in paragraph 5.4.
Access to the battery is achieved by tipping the cover (3).
- If necessary, check the liquid level in battery cells.
- The remaining capacity of the battery can be checked with an
acidometer (see 5.1).
3) Check switch (4). Check cable connections on switch.
4) Check control current fuse: 5 A (6).
If the fuse is intact and the truck does not drive, contact the dealer.
5) Check main fuse for driving motor: 80 A (7).
Check cable connections on drive motor and pump motor.
If no fault can be found and the truck does not drive, contact the dealer.
6) Check the wire connections between the battery cells, and to the battery. In case of
verdigris on the connections, these are to be cleaned.
Check that all cable connections are fixed.
7) Check the wiring loom on the side of the wheel motor. Check that the brake is acti-
vated when the handle is activated. Check that the brake is adjusted correctly.
If no fault can be found and the truck still brakes, please contact the dealer.
8) Brake needs adjustment.
Lift the forks and turn the adjusting screw on the brake side of the wheel
motor. Turn clockwise to tighten the brake.
9) Fill in oil through filler (8). The oil level must reach the underside
of the filling plug.
Oil type:
Hydraulic oil ISO VG 15 (factory-filled with Texaco Rando HD 15).
Max. load given on name plate. If the truck can not lift the load, given on
the name plate, contact the dealer.
10) Check the fuse for the pump motor: 50 A (9).
If the fuse is intact and the truck does not lift, contact the dealer.
11) Locate the oil leak and contact the dealer.
To localise the leak it is necessary to remove the rear cover (5).
12) Check the fuse for the charger.
13) Place the handle in drive position before turning the forward/reverse knob.