Logitech G G923, Setup Manual

Page: 11 / 47

11 ENGLISH
2 Press the button you want to set as the dual clutch button
The only valid buttons for this are the left stick button (LSB)
and right stick button (RSB) The RPM LEDs will flash red
to show that you’re in clutch position setting mode
3 While in your chosen simulation or game with the car still on
a track, fully depress the clutch and gas pedals Engage first
gear and keep pressing the minus button down until the car
begins to move in-game You can adjust the precise bite
point of the clutch by using the plus and minus buttons until
you are happy with the setting
4 At this point you may test the dual clutch without
leaving the setting mode It is recommended you attempt
a race start, stop the car and adjust the bite point and
then try again until you are satisfied with the performance
of the dual clutch
5 Press the Select button in the middle of the dial on the wheel
to exit dual clutch setting mode The RPM LEDs will flash
in a sequence from green to blue to show that the setting
is saved The RPM LEDs will then go out and begin responding
again to RPM output from supported games